PEL-5000G Series DC Electronic Load
PEL-5000G Series DC Electronic Load
PEL-5000G Series DC Electronic Load
PEL-5000G Series DC Electronic Load
PEL-5000G Series DC Electronic Load
PEL-5000G Series DC Electronic Load
PEL-5000G Series DC Electronic Load
PEL-5000G Series DC Electronic Load

PEL-5000G Series DC Electronic Load

¥999,999.00
  
  • Quantity
    • -
    • +
  •    
Inquire about this product
  • 4U/6K high power density design for easy desktop testing
  • Turbo Mode function uses 1.5 times the rated power or rated current in less than two seconds
  • Turbo Mode can be used with OCP/OPP/BMS/Short Mode/Surge Mode/Hot Plug-In tests.
  • High ambient temperature tolerance, 4k/5kW models use power independent of ambient temperature.
  • Power-on status value can be set
  • Short circuit time can be set during short circuit test.
  • The voltage polarity display can be set to a positive ("+") or negative ("-") value.
  • Optional interfaces: GPIB, RS-232C, USB, LAN
  • Provide battery BMS protection board protection function test
  • Overcurrent, power, temperature protection and overvoltage alarms

The PEL-5000G series of single-channel electronic loads offer three rated voltage settings of 150V / 600V / 1200V, and power ranges from 4kW to 6kW. The PEL-5000G is available in nine models to meet different combinations of power, voltage, and current, and is suitable for server power supply testing and validation, power carrier chargers/charging stations, and power/storage battery testing needs. The PEL-5000G offers parallel connection of the same models and supports parallel connection of up to 8 units in Master/Slave architecture, delivering up to 48kW of power.

For battery charger test applications, the PEL-5000G provides four battery discharge modes, namely CV+Current Limit mode, CV+Power Limit mode, CC mode and CP mode. Users can select the appropriate test mode according to the test requirements. Under the Battery Discharge Function, you can choose to set the discharge cut-off voltage, discharge time or discharge capacity (Ah) in CC or CP mode to meet the battery test requirements.

To meet the verification needs of different DUTs, the PEL-5000G offers a variety of test functions, including inrush current test mode, OCP and OPP protection test functions for the object to be tested, and 150 sets of parameter storage.The 1200V model of the PEL-5000G not only provides full power output at 1000V, but also retains 60% at 1200V output. The PEL-5000G 1200V model not only provides full power output at 1000V, but also retains 60% of power bandwidth capacity at 1200V output, which is higher than the 50% specification of other electronic load manufacturers. Additionally high voltage (>600V) batteries or chargers connected directly to the electronic load may cause damage to the electronic load. the PEL-5000G has a built-in slow starter that protects the DC load and also saves the user installation costs and setup time for measurements on the 600V/1200V model.

Communication interfaces supported by the PEL-5000G include GPIB, RS232, USB, and LAN.The power, voltage, and current for each model are shown in the table below:

Power / Voltage 150V 600V 1200V
4kW PEL-5004G-150-400 (400A) PEL-5004G-600-280 (280A) PEL-5004G-1200-160 (160A)
5kW PEL-5005G-150-500 (500A) PEL-5005G-600-350 (350A) PEL-5005G-1200-200 (200A)
6kW PEL-5006G-150-600 (600A) PEL-5006G-600-420 (420A) PEL-5006G-1200-240 (240A)

Standard Accessories

sls10b red; plug conn 20a red t × 1
sls10b blk; plug conn 20a blk t × 1
PTV1-12; PIN TRML × 4
HD-DSUB 15pin MALE to MALE 150cm × 1
RND SCREW M4x0.7+S+P L=20mm × 4
Hexagon head M8*1.25 L=25mm NI × 2
k-nut m4x0.7 ni × 4
NUT M8X1.25 NI × 2
WASHER INSIDE DIA-8.5 OUTSIDE × 4
SPRING WASHER INSIDE φ8 × 2
PEL-5004G,PEL-5005G,PEL5006G handles : PEL-028 × 1
Rack Mount Kit For PEL5004G,PEL-5005G,PEL-5006G : PEL-031 × 1

Optional Accessories

PEL-030 GPIB+RS232 Interface
PEL-023 RS232 Interface
PEL-032 9923+RS232 Interface
PEL-022 GPIB Interface
PEL-025 USB Interface + USB Driver
(Drivers can be downloaded)
PEL-024 LAN Interface + LAN Driver
(Drivers can be downloaded)
GTL-250 GPIB Cable, 1m GPIB cable
GTL-248 GPIB Cable, 2m GPIB cable
GTL-246 USB Cable, 1.2m USB cable

 

Ordering Information

General mode*

  • PEL-5004G-150-400 (150V,400A,4kW)
  • PEL-5005G-150-500 (150V,500A,5kW)
  • PEL-5006G-150-600 (150V,600A,6kW)
  • PEL-5004G-600-280 (600V,280A,4kW)
  • PEL-5005G-600-350 (600V,350A,5kW)
  • PEL-5006G-600-420 (600V,420A,6kW)
  • PEL-5004G-1200-160 (1200V,160A,4kW)
  • PEL-5005G-1200-200 (1200V,200A,5kW)
  • PEL-5006G-1200-240 (1200V,240A,6kW)

 

multiplier model*

  • PEL-5004G-150-400 (150V,600A,6kW)
  • PEL-5005G-150-500 (150V,750A,7.5kW)
  • PEL-5006G-150-600 (150V,900A,9kW)
  • PEL-5004G-600-280 (600V,420A,6kW)
  • PEL-5005G-600-350 (600V,525A,7.5kW)
  • PEL-5006G-600-420 (600V,630A,9kW)
  • PEL-5004G-1200-160 (1200V,240A,6kW)
  • PEL-5005G-1200-200 (1200V,300A,7.5kW)
  • PEL-5006G-1200-240 (1200V,360A,9kW)

For product delivery dates, please contact your local sales office.

Expand More
PEL-5000G Series DC Electronic LoadPEL-5000G Series DC Electronic Load
¥999,999.00
Purchase of goods

Product consultation and purchase:18218718851

I already understand